Palo alto networks vpn stuck phase 1 after reboot

PALO ALTO NETWORKS VPN STUCK PHASE 1 AFTER REBOOT LICENSE KEY

dst src state conn-id slotДЎ2.1.1.2 12.1.1.1 QM_IDLE 1 0 show crypto ipsec sa This command shows the Internet Security Association Management Protocol (ISAKMP) security associations (SAs) built between peers. Refer to Common IPsec Error Messages and Common IPsec Issues for more details. The topics in this section describe the Cisco IOS Software debug commands. Refer to Cisco Technical Tips Conventions for more information on document conventions.

If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment.

PALO ALTO NETWORKS VPN STUCK PHASE 1 AFTER REBOOT LICENSE KEY

PIX-V5.0 and later, which requires a single or triple DES license key in order to activate. Triple DES is available on the Cisco 2600 series and later. K2-Indicates triple DES feature (on Cisco IOS Software Release 12.0 and later). The information in this document is based on these software and hardware versions:ДҐ6i-Indicates single Data Encryption Standard (DES) feature (on Cisco IOS Software Release 11.2 and later). There are no specific requirements for this document. It contains a checklist of common procedures that you might try before you begin to troubleshoot a connection and call Cisco Technical Support. Refer to Most Common L2L and Remote Access IPsec VPN Troubleshooting Solutions for information on the most common solutions to IPsec VPN problems.

This document assumes you have configured IPsec. This document describes common debug commands used to troubleshoot IPsec issues on both the Cisco IOS ? Software and PIX/ASA.

Palo alto networks vpn stuck phase 1 after reboot